SMSL SK10 Mark II 2nd MINI Audio High end DAC

Description

SMSL SK10 Mark II(2nd Sanskrit 10th)- New Version

AK4493 High-end MINI Audio DAC Decoder PCM 32Bit/384kHZ DSD256 support OTG Remote control

* From March 11, 2020, All order will be New version of Sanskrit 10th MARK II.

Specifications:

Ultra-tiny shape design and supports a variety of placement ways;
The second-generation XMOS solution supports sampling rate up to 32bit/768KHz and DSD256;
Two pieces of Japanese ultra-low phase noise clocks, greatly reducing the system JITTER;
AKM’s new AK4493 chip, and carefully adjusted it to an unprecedented 0.0002%;
Built-in gravity sensor, automatically switches the screen ! Built-in high-performance power filtering system, so that it can achieve the best performance using only one USB interface for power supply ! Anodized CNC aluminum alloy housing;
Japan Electronics Association Hi-Res Audio certification;
Full-featured remote control .

Operating the remote control：

* Note
1. This remote controller use 2 x R03/AAA batteries.
2. When you first operate Sanskrit 10th, press the C key first.

Install 2 x AAA batteries as instructions.
When using the remote control, point it toward the remote con-trol signal receiver on the main unit from a distance of 5 m (16 ft) or less. Do not place obstructions between the main unit and the remote control.
The remote control might not work if the remote control signal receiver on the unit is exposed to direct sunlight or bright light. If this occurs, try moving the unit.
Beware that use of this remote control could cause the unin-tentional operation of other devices that can be controlled by infra.

Parts Introduction

Note:
1. This is the Aux power input, when you use phones to connect the USB, you
need to connect a 5V DC power for avoiding the phone overcurrent ;
2. You cannot use the Quick-Charge power for this connector, because of the
Quick-Charge power may output over 5V, which is dangerous for this unit！